Side stand Ignition Cutout Switch

 Sorry, this part is no longer available.

 03759100 GU03759100 03 75 91 00
 0375 9100 0375.9100 03.75.91.00

Starter motor deposit, buy this deposit if you are buying one of our reconditioned starter motors and we haven't already received your servicable exchange unit. This deposit will be refunded once we receive your complete reconditionable Valeo or Bosch starter and solenoid

 More than 5 in stock

Ignition pickup and tacho sensor

Connector plug has two male spades. Also known as phase sensor. Used on models with the large Marelli P8 ECU. No longer available from Guzzi. Note 90° angle where cable exits sensor. See ENA90141 for O ring used to fit this part

 1 in stock

 29721660 GU29721660 29 72 16 60
 2972 1660 2972.1660 29.72.16.60

Marelli air temperature sensor

Supplied with screws. Two required per engine

 1 in stock

 30729330 GU30729330 30 72 93 30
 3072 9330 3072.9330 30.72.93.30

Neutral switch

Also known as Guzzi ref. 19207200

 1 in stock

 19207220 GU19207220 19 20 72 20
 1920 7220 1920.7220 19.20.72.20

Left hand Domino type switchgear with high and low beam, pass, indicator and horn switches. Same style switch as ELA01738

On most bikes this will not plug directly into the wiring loom, you will need to match the wires to your loom. An indication of wire colours is supplied with this switchgear. Supplied with 9 pin block connector. NB does not have lights off - park - on function, you need this to be on your RH switch (e.g. ELA01729 ) or run lights always on

 This part is available by special order, request a quote

Domino left hand switchgear with lights on - park - off, high and low beam, pass, indicator and horn switches. Same style switch as ELA01738.

Already wired in to 9 pin block connector (you may need to alter the wiring on your bike to correspond to this block connector). Originally fitted as standard to early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear. See Greg Bender's website for a custom sub-loom that enables easy fitting of this part to models previously fitted with LEGO style swithgear

 This part is due back in stock soon, call 01484 841395 to reserve yours

 01738030 GU01738030 01 73 80 30
 0173 8030 0173.8030 01.73.80.30

TPS for throttle body

On Cali 1100 check which TPS you have (varies according to ECU)

 This part is available by special order, request a quote

 01530500 GU01530500 01 53 05 00
 0153 0500 0153.0500 01.53.05.00

Timing sensor for ignition and tacho

3 pin block connector. Used on models with the smaller 15M ECU

 2 in stock

 01721600 GU01721600 01 72 16 00
 0172 1600 0172.1600 01.72.16.00

Lambda sensor. Wiring harness may be shorter that your existing connector on some modeels, and will therefore need extending.

 This part is available by special order, request a quote

 32727010 GU32727010 32 72 70 10
 3272 7010 3272.7010 32.72.70.10